When changing the mold follows the injection molding machine manufacturer’s instruction at all times to avoid the possibility of serious injuries to the machine operators. After you fix the mold on injection molding machine, please ensure that all the parameters for the mold and the injection unit had been properly aligned to avoid damage to the machine. In addition, you must make sure that the barrel/mold platen units are properly connected, and mold had been mounted securely.
1.1.1 Mold height adjustment
During the installation of the plastic injection mold, please use the Mold Adjustment keys 
to adjust for mold thickness.Press the Reduced Mold Height Adjustment key 
to roughly reduce the mold height (reduce distance between moving and static platen), or press the Increased Mold Height Adjustment key 
to increase the mold height (the distance between the moving and static platen).
For continuos platen movement press and hold the key.The platen will move slightly and stop. Keep the key pressed and after one-second delay the platen will start to move continuously. If you press the key and release it immediately, the platen will move slightly and stop,, allowing for micro adjustment. You can repeat such operation until the moving platen had reached the required position.
Caution: Regarding to the safety issue, please stop the motor from operating and turn OFF the machine while installing the new mold.
Once you have finished the installation of the new mold, close the safety gate, then turn the machine ON and press the Maual Mold Height Adjustment ON/OFF key once to activate the Manual Mold Height Adjustment mode.After the adjustment of the mold, you could change the mold height speed and pressure setting by using the nozzle display.
If necessary, you could either set a mold date for your new mold or load on the mold set data. After the adjustment setting, press the Manual Mold Height Adjustment ON/OFF key again to switch to the automatic Manual Operation mode. While closing the mold the controller will execute an automatic mold height adjustment until the new settings are reached.Once the automatic adjustment has finished all machine operations will stop and the alarm will sound. This indicates that you can now switch back to manual or automatic operation modes.
Warning: For the safety reasons, you have to switch the machine into Manual Operation mode by pressing Manual key before you use the Mold Height Adjustment key or Manual key. If you wish to use any other mode, please change to the Manual mode before switching to the mode you required.
If you encounter any problems during the mold height adjustment, press the Manual key 
or the emergency stop key to stop the operation.
SPECIAL PROMOTION
